£
Vulcan Analogue Equipped Heat Exchanger by Elecro
Top reasons to buy
Available in four sizes, from 25kW (85,000 BTU) to 100kW (341,000 BTU). Fully equipped with Analogue control thermostat; Grundfos booster pump; and flow switch.
Robust, durable construction; Titanium tube bundle; straight through water path; 316 Stainless Steel shell with special polyamide fittings; can be floor or vertically wall mounted.
If you have a question about this product, please use the area below, click 'SUBMIT' when you're done and we'll get back to you ASAP!
Product Detail
Available in four sizes, from 25kW (85,000 BTU) to 100kW (341,000 BTU). FEATURES:
- Fully equipped with Analogue control thermostat; Grundfos booster pump; and flow switch.
- Volt-free contact for heating appliance control
- Robust, durable construction
- Titanium tube bundle
- Straight through water path
- 316 Stainless Steel shell with special polyamide fittings
- May be floor or vertically wall mounted
CONSTRUCTION:
The Elecro heat exchanger is manufactured from top quality components and material at the Elecro works in Hertfordshire, England.
Construction consists of a densely populated multi-tubular pure Titanium tube bundle which is secured by the purpose designed polyamide / rubber tube sheet. The heat exchanger shell is constructed from BS 316 Stainless Steel this is capped at each end with primary and secondary moulded fittings manufactured from specially formulated polymer alloy material
The heat exchanger is supported on two swivel feet; to facilitate either wall or floor mounting.
The Analogue equipped heat exchanger is supplied complete with:
- Analogue control thermostat
- Grundfos booster pump
- Flow switch (with gold tipped reed switch)
- 2 x 1" male/male Brass primary connections
- 1 x 1" Brass Non-return valve
- 1 x 1" female/female brass connection
- 1 x Titanium thermostat pocket
-
1 x Blanking cap & coin gasket (for non-thermostat side)
The Elecro analogue equipped heat exchanger has been designed to allow the installation engineer to select which way to plumb the primary and secondary water to achieve maximum thermal gain, this is achieved by routing the primary (HOT) flow in an opposing direction to the secondary (POOL) water.
OPERATION:
The required pool temperature can be easily selected by rotating the thermostat dial to the required temperature. When the incoming pool water reaches the desired temperature the thermostat switches the booster pump and heating appliance off. The booster pump and heating appliance is switched back on if the pool water temperature falls below the required temperature.
A volt-free contact is supplied; this can be wired to the heating appliance to switch it on and off.
Elecro heat exchangers are ideal for use with gas or oil fired boiler circuits, solar panels, heat pumps or chillers.
SPECIFICATION:
Tube bundle: Pure Titanium
Water connections: 1½" or 50-mm rigid pipe
Heating circuit connections: 1" BSP
Maximum operating pressure: 4 bar
Mounting: Floor or wall mountable
Product Specification
| Brand: | Elecro | Range: | Vulcan |
| Code: | V-HE-ANA |
You May Also Like
Reviews
